To service a set of bushings, you must first type in the OEM bushing number to see if there is an available Pin & Bushing Adapter Kit available from Tiger Tool.
Please note: The Pin & Bushing Starter Kit requires at least 1 Adapter Kit in order to operate.
Below is the Adapter Kit required for your application and Pin & Bushing Starter Kit.
To continue, add to your Adapter Kit to the cart.
|10915||Set 401/402/430 Adapter||$269.99|
|10916||Set 403/404/429/433 Adapter||$269.99|
|10917||Set 412/413/427 Adapter||$269.99|
|10918||Set 414 Adapter||$269.99|
|10919||Set 415 Adapter||$269.99|
|10920||Set 423 Adapter||$269.99|
|10921||Set 406 Adapter||$269.99|
|10922||Set 409/410/416 Adapter||$269.99|
|10923||Set 408 Adapter||$269.99|
|10924||Set 424 Adapter||$269.99|
|10925||Set 418/419/420 Adapter||$269.99|
|10926||Set 421/422 Adapter||$269.99|
|10927||Set 411/426 Adapter||$269.99|
|10928||Set 405 Adapter||$269.99|
Technicians who use our Bearing Race Service Kits benefit from a 25-30% reduction in service time, with time savings upwards of thirty minutes per hub!
Our patent-pending method for installing bearing races seats the new race perpendicular to the bore and utilizes bearing specific adapters to apply even pressure until the race is perfectly seated—every time.
Traditional methods notoriously cause damage to the walls of the bore as the race cocks from side to side. Our system mitigates this damage and eradicates the inevitable slag being burnt into the hub.
Keep it safe.
Servicing bearing races is no easy feat, and traditional methods put technicians at risk. Anyone who’s been faced with a seized race and armed with only a hammer and punch can relate all too well to the inherent danger of striking one’s own hand.
The traditional Hammer & Punch method can cause damage to the bearing race bore inside the hub.
This can cause the new race to seat improperly leading to premature bearing/seal failure and cause uneven tire wear. As the punch makes multiple side-to-side strikes to the race, it causes the race to come out in an un-parallel motion causing damage to the hub’s machined surface.
This kit eradicates the inevitable welding slag from damaging and contaminating the inside of the hub. If gone unnoticed, even the smallest amount of slag can make its way back into the bearing assembly causing premature failure.